Main:+86 574 87907106
[email protected]
Custom Aluminum CNC Machining Parts Manufacturers
The surface processing method of CNC machined parts firstly depends on the technical requirements of the machined surface. However, it should be noted that these technical requirements are not necessarily the requirement...
1: Reduce the number of tooling greatly, because CNC machining is mainly processed by programming, and CNC has three axes, four axes, and five axes. Compared with other ordinary machining equipment, processing parts with...
Leaks that may occur in pneumatic control valves: (1) Valve leakage Due to the improper length of the valve stem, the upper and lower parts of the valve stem are too short, resulting in incomplete contact between the val...
The main components of the pneumatic control valve： 1. Pressure reducing valve: reduce the pressure of the control air source to suit the working pressure of the actuator; 2. Filter: Filter out the water and other impuri...
On November 12, the fifth meeting of the 5th Council of China Hardware Association and the 30th anniversary of the founding of the Association was held in Beijing. More than 300 leading guests from the Chinese hardware i...
Main:+86 574 87907106
Main:+86 574 87907106
